Useful Links
DMG 1000/2000 Popular links Integration Notes Integrating other PBXs Microsoft® OCS 2007 (PDF) DMG 1000/2000 Downloads Firmware Reference Firmware Downloads Documentation DMG 3000/4000 Popular links Create basic configuration DMG 3000/4000 Downloads Documentation Product pages Enterprise Media Gateways Microsoft® Unified Communications Resources Media Gateway Forum Contact Dialogic Support Contact Information Search Helpweb Other areas Developer Center Discussion Forums Online Training Application Notes Resources Authorised Distributors RMA Instructions

> Services & Support > Support Helpweb > Dialogic® Media Gateways

Dialogic Support Helpweb

Dialogic® Media Gateways (DMG series)

Integrating DMG1000, DMG2000, DMG3000, DMG4000 Media Gateways with PBXs

The PBXs listed on the Integration Notes page and in the Product Briefs are those with which Dialogic has tested the Dialogic DMG 1000 and DMG 2000 Media Gateways.

However, almost any PBX will work with the DMG-series Media Gateways if it meets both of the following requirements:

1. It provides one of the following types of connections or interfaces:

Analogue phone connections. These PBXs will work with the DMG1000LS series, OR
Digital handset connections (DMG1000DNI series) *, OR
E1/T1 ISDN interface(s) (DMG2000 and DMG4000 series), OR
BRI ISDN interface(s) (DMG3000 series)

2. It provides the numbers required by the application; for instance, for Microsoft Exchange Unified Messaging (UM) implementations you will need the redirected number and the called party number, while for Microsoft Office Communication Server (OCS) you will need the called party number and the calling party number. Other IVR applications may need different combinations of these numbers to be delivered in order to work effectively.

These numbers can be delivered in the following ways:

for analogue connections, either in-band using DTMF or FSK or out-of-band using a serial connection
using a digital handset connection *
using the Q.SIG or ISDN protocol on E1/T1 ISDN lines
using the Q.SIG or ISDN protocol on BRI ISDN lines

* Note: For a list of supported digital handsets see Table 1 in this document

If a PBX meets these requirements, it is probable that you can configure the Dialogic Media Gateway to work with that PBX.

You can use any of our Integration Notes for the gateway model that you have as a guide to configuring the gateway to work with your PBX.

For further information, see

Dialogic Support Helpweb

Dialogic® Media Gateways (DMG series)

Integrating DMG1000, DMG2000, DMG3000, DMG4000 Media Gateways with PBXs

Feedback

Please rate the usefulness of this page:

Please enter a comment about this page: