Installing the SNMP Agent on a Solaris SPARC

This procedure describes the installation of the SNMP Agent on a Solaris SPARC system.

Before you begin

If an SNMP Agent is already installed, you must first uninstall it before continuing. Please refer to the procedure Uninstalling the SNMP Agent on Solaris SPARC. If you are not sure if there is a previous version installed, check for one with the following command:

> /etc/srconf/exe/CSPAgent -v

If this command works, then there is an SNMP agent already installed. If snmpdx process or other SNMP processes are running, then stop the processes and uninstall them.

EXS SwitchKit must be installed and the LLC needs to run. Refer to the EXS SwitchKit Installation and Maintenance Guide for further information.

Installing SNMP on
Solaris SPARC

To install the SNMP Agent, follow the steps below:

1 Log in as user root.

2 Run the installation script with the command:

#./install.sh

3 If you try to run the script and the tar file is not found, the following message is displayed:

# Installation media not found

4 The following shows the screen output of InstallAnywhere. When you are asked to press enter to continue, do so:

5 When the installation is complete, snmpdm and mib2agt will have executed. You can verify this with the following commands:

# ps -ef | grep snmp

# ps -ef | grep mib2