TDM DS3 Span Profile (Software 10.5.0 & IMG1010 only)

Description:

Once the DS3 Interface has been created, each individual DS1 will need to be configured. Follow the procedure below to accomplish this.

 

Accessing this Pane:

Dialogic IMG EMS -> Logical IMG -> Physical IMG -> Facility -> TDM DS3 > TDM Spans

 

Maximum Objects:

1 per Physical IMG

 

Related Topics:

DS3_Physical_Span_Conf - 10.5.x

 

ClientView Pane:

sc_tdmspan_ds3_10-5-0.png

 

Field Descriptions

Interface:

The interface will default to Bearer and cannot be changed

Offset - x Configuration:

Each individual Span can be configured by a drop down menu. Below are the drop down menu selections.

Not Used - The Span will not be used

Local Loopback - Loops back transmit and receive on that individual span so that a far end piece of equipment can send a test such as a BERT test towards the local IMG. The span on the front panel of IMG 1010 will blink orange when offset is in local loopback.

Remote Loopback (CBIT only) - The local IMG sends out a FEAC code to a far end piece of equipment telling an individual span to go into loopback mode (Loopback Transmit and Receive) so the local IMG can send out a test such as BERT test. The span on the front panel of IMG 1010 will display solid orange when offset is in remote loopback.

Profile - This will be a drop down menu of all the TDM profiles created under the Profiles Object in ClientView. In screen capture above the IMG is configured for T1 over DS3.

 

Note: Following the request to put DS1 offset 14 in loopback, you CANNOT make another request for loopback on another span without first taking span 14 out of loopback.

 

Monitoring Fields:

Available Span Count:

The number of Spans available and not being used

Licensed Span Count

Number of DS3 Spans licensed

 

Radio Buttons:

Facility Wizard:

If the facility wizard button is clicked the a dialog box will appear allowing you to configure a range of spans instead of configuring each individual span. Below is screen capture of the facility wizard dialog box that will appear.

 

sc_facility_wiz_ds3.png

 

Profile - Select from a drop down list all the TDM profiles created under the Profiles object in ClientView

Start Interface ID - Select from a drop down menu the starting Span

Span Count - Select from a drop down menu the number of spans to configure