This topic describes:
The specific use of each stream, as shown for H.110 streams and local streams
An illustration of the CX 2000C switch model
|
H.110 streams |
|
|---|---|
|
H.110 Bus |
Streams 0..31, timeslots 0..127 (Streams clocked at 8 MHz) |
|
Local streams |
|
|---|---|
|
Station voice information |
Stations 0 - 47: Streams 0 and 1, timeslots 0..47 for 48 ports Stations 0 - 31: Streams 0 and 1, timeslots 0..31 for 32 ports |
|
Station signaling information |
Stations 0 - 47: Streams 2 and 3, timeslots 0..47 for 48 ports Stations 0 - 31: Streams 2 and 3, timeslots 0..31 for 32 ports |
|
DSP voice information |
Streams 4 and 5, timeslots 0..47 for 48 ports Streams 4 and 5, timeslots 0..31 for 32 ports |
|
DSP signaling information |
Streams 6 and 7, timeslots 0..47 for 48 ports Streams 6 and 7, timeslots 0..31 for 32 ports |
The following illustration shows the CX 2000C switch model:
CX 2000C board switch model
Switching on the CX 2000C board is implemented by the Lucent T8100A chip (HMIC). The Lucent T8100A chip can perform local bus to local bus switching in full non-blocking fashion.
The number of H.110 connections is limited to a maximum of 128 full duplex or 256 simplex (or half duplex) connections, in any combination, from either the:
H.110 bus to the local bus
H.110 bus to H.110 bus