The Health Management Interface (HMI) runs as a service under Windows. After installation of the software, the HMI is installed as a Windows service in a default state of disabled.
Note: To use Hot Swap, the HMI service must be removed (hmi -remove) and re-installed with the -hsinstall option..
To start the HMI service, reboot the system or perform the following steps:
|
Step |
Action |
|
1 |
From the Control Panel, select the Services icon. |
|
2 |
Choose the Dialogic TX HMI service. |
|
3 |
Click Start. |
On subsequent system boots, the service is started automatically.
Note: Before starting the HMI service, the HMI configuration file must be created or updated. Refer to HMI configuration.