Controlling M3UA entities

Use M3uaMgmtCtrl to enable the application to control M3UA entities. The following table describes the available control requests by entity:

Entity

Control request

None specified

One of the following general control requests:

  • Enable or disable alarms.

  • Start or stop debug logging.

  • Start flow control and disable the transmission of all M3UA messages except critical messages.

  • End flow control and enable the transmission of all M3UA messages.

  • Shut down the M3UA layer.

  • Start or stop trace data

ASP

Send any of the following messages:

  • ASP Up

  • ASP Down

  • ASP Active

  • ASP Inactive

 

Note: Use these messages for debugging purposes only. They are sent automatically by the M3UA layer and should not usually be sent through the management API.

Association

Any of the following:

  • Inhibit or uninhibit the association.

  • Establish or terminate the association.

  • Dynamically change the Type Of Service octet for all IP messages across this association.

 

Note: Establish or terminate an association for debugging purposes only. This is performed automatically by the M3UA layer and should not usually be performed through the management API.

Routing key

Register or de-register a dynamic routing key.

Note: Dynamic routing keys are not currently supported.

SCT SAP

Enable or disable the SCT SAP.

Note: Enable or disable the SCT SAP for debugging purposes only. These actions are performed automatically by the M3UA layer and should not usually be performed through the management interface.