The [blst] command set is available on TX 5000 Series boards.
The [blst] commands are used during TX board evaluation to establish a test message flow over the full set of external communication interfaces including host bus (application communication), UDP and SCTP (IP protocols) and MTP1 (over TDM).
The following table lists the [blst] commands:
|
[blst] commandsv |
Description |
|
usage |
Display blast command line options. |
|
config |
Display blast configuration. |
|
stats |
Display blast statistics. |
|
start |
Start traffic load test (out VSOCK <ADDR> provided). |
|
size |
Set the test packet size. |
|
cycle |
Set disable/re-enable cycle time. |
|
reflect |
Set reflect wait time (in msecs). |
|
numout |
Set number of TXs to keep outstanding. |
|
total |
Set total number of packets to send. |
|
bandwidth |
Set outbound data bandwidth limit (in kilobits per second). |
|
rxtrigger |
Set whether receive triggers next send. |
|
rxignore |
Set whether RXs that are ignored are alarmed. |
|
rxlimited |
Set whether Limited Pool attached to VSOCK RX. |
|
txcomplete |
Set whether TX complete notifications desired. |
|
ipopt |
Control use of IP options. |
|
rxipopts |
Display last received IP options. |