The [brdg] command set is available on TX 5000 Series boards.
The [brdg] commands are used during TX board evaluation to receive and forward a test message flow over the full set of external communication interfaces including host bus (application communication), UDP and SCTP (IP protocols) and MTP1 (over TDM).
The following table lists the [brdg] commands:
|
[brdg] commands |
Description |
|
config |
Display bridge configuration. |
|
stats |
Display bridge statistics (optionally zeroing after display). |
|
side |
Configure one side of the bridge. |
|
routereg |
Register VSOCK for receipt of route change notifications. |
|
routelog |
Log all current routes as alarms. |
|
icmpreg |
Register VSOCK for receipt of ICMP error notifications. |
|
start |
Start the bridge (optionally acting as a sink). |
|
rxlimited |
Set whether Limited Pool attached to VSOCK RX. |