The [t1e1] command set provides full control of all T1/E1/J1 capabilities on the board. Use the following commands to diagnose TDM communication problems on the T1, E1, or J1 interfaces:
|
[t1e1] commands |
Description |
|
ais |
Transmits an alarm indication signal. |
|
chanloop |
Places a single framer channel in loop mode. |
|
ctx |
Displays the T1/E1/J1 top-level control context. |
|
defect |
Inserts single bit defects. |
|
disable |
Disables the framer. |
|
e1cfg |
Configures the framer as E1 mode. |
|
e1opt |
Sets the E1 configuration option. |
|
enable |
Enables the framer. |
|
frcfg |
Shows the current framer configuration. This command is also present in the [con] Standard commands. |
|
frstats |
Shows statistics for the framer. This command is also present in the [con] Standard commands. |
|
frstatus |
Shows the current framer status. This command is also present in the [con] Standard commands. |
|
info |
Displays top-level information for each framer. |
|
j1cfg |
Configures the framer as J1 mode. |
|
j1opt |
Sets the J1 configuration option. |
|
llbdown |
Transmits a line loopback deactivate code. |
|
llbup |
Transmits a line loopback activate code. |
|
loop |
Places the entire framer in loop mode. |
|
prbs |
Transmits a pseudo-random bit sequence. |
|
ra |
Transmits a remote alarm. |
|
resync |
Forces framer resynchronization. |
|
sim |
Initiates an alarm simulation or advances to the next test. |
|
t1cfg |
Configures the framer as T1 mode. |
|
t1opt |
Sets the T1 configuration option. |