The following table describes NCC.X.ADI_START.dial parameters:
|
NCC.X.ADI_START.dial |
||||
|---|---|---|---|---|
|
Dependent functions: nccStartProtocol |
||||
|
Field |
Type |
Default |
Units |
Description |
|
breaktime |
DWORD |
60 |
ms |
Break (on-hook) duration for dial pulses. |
|
dialtonewait |
DWORD |
5000 |
ms |
Maximum time to wait for dial tone (applies only to the semicolon (;) character). Valid range is 0 to 65535. |
|
dtmfampl1 |
INT32 |
-6 |
dBm |
Amplitude of the low frequency component of the DTMF pair. Valid range is -54 to -3. |
|
dtmfampl2 |
INT32 |
-4 |
dBm |
Amplitude of the high frequency component of the DTMF pair. Valid range is -54 to -3. |
|
dtmfofftime |
DWORD |
80 |
ms |
Duration of the silence time between each digit. Valid range is 0 to 65534. |
|
dtmfontime |
DWORD |
80 |
ms |
Duration of each DTMF or MF digit. |
|
flashtime |
DWORD |
500 |
ms |
Amount of time to assert the on-hook signaling pattern for a flash (!)
character. |
|
interpulse |
DWORD |
700
|
ms |
Inter-digit time for pulsed dialing. |
|
longpause |
DWORD |
5000 |
ms |
Amount of delay associated with the period (.) character. Valid range is 0 to 65535. |
|
maketime |
DWORD |
40 |
ms |
Make (off-hook) duration for dial pulses. |
|
method |
DWORD |
0 |
mask |
Type of signaling: 0=DTMF, 1=Pulse, 2=MF (US). |
|
reserved |
DWORD |
0 |
internal |
Do not modify. |
|
shortpause |
DWORD |
2000 |
ms |
Amount of delay associated with the comma (,) character. Valid range is 0 to 65535. |
|
tonebandw1 |
DWORD |
40 |
Hz |
Bandwidth of the first frequency of the dial tone detector. Valid range is 20 to 800. |
|
tonebandw2 |
DWORD |
40 |
Hz |
Bandwidth of the second frequency of the dial tone detector. Valid range is 20 to 800. |
|
tonefreq1 |
DWORD |
350 |
Hz |
First (or only) dial tone frequency. |
|
tonefreq2 |
DWORD |
440 |
Hz |
Second dial tone frequency. Set this to 0 to detect a single frequency. Valid range is 330 to 3600. |
|
tonequalampl |
INT32 |
-28 |
dBm |
Minimum broadband signal amplitude to qualify for dial tone detection. Valid range is -40 to 0. |
|
tonequaltime |
DWORD |
50 |
ms |
Minimum duration of a qualified tone to be considered dial tone. Valid range is 0 to 32767. |
|
tonereflevel |
DWORD |
0xb000 |
IDU |
Do not modify. |
|
tonetotaltime |
DWORD |
0 |
ms |
Total time interrupted dialtone must be present. |