Configuring CPU Monitoring

Select PowerMedia WMS>Configure>Media Engine to configure CPU monitoring parameters.

All user access levels can view the configuration, but only Administrators can change the configuration.

Warning: The commands in this configuration section manipulate the configuration file. To apply a new configuration, reboot the PowerMedia WMS.

Follow these steps to configure CPU monitoring parameters:

  1. Select PowerMedia WMS>Configure>Media Engine to display the Configure Media Engine page.

  2. Click the Enable CPU Monitoring checkbox. CPU Load parameters are displayed:

% CPU Load to Reject New Calls (default value 85%)
% CPU Load to Accept New Calls (default value 80%)

Note:   The value for % CPU Load to Accept New Calls must be less than or equal to the value for % CPU Load to Reject New Calls. If it is higher, the system will reset it to equal the value for % CPU Load to Reject New Calls.

  1. Modify the value as needed for % CPU Load to Reject New Calls. When this CPU threshold value is exceeded, PowerMedia WMS rejects any new calls.

  2. Modify the value as needed for % CPU Load to Accept New Calls. After the Reject New Calls threshold is exceeded, the CPU load must fall below the Accept New Calls threshold in order for calls to be accepted by PowerMedia WMS.

  3. Click OK.

  4. Reboot the PowerMedia WMS to apply the changes.