Hardware differences: AG 4040C to CG 6060C

The following table describes the hardware differences between AG 4040C and CG 6060C boards:

Item

AG 4040C board

CG 6060C board

Board status LEDs

No board status LEDs.

Red, yellow, and green board status LEDs.

Bus support

Supports 32-bit, 33 MHz CompactPCI bus.

Supports 32-bit, 33 MHz or 66 MHz CompactPCI bus.

CAS signaling

Processed in a DSP.

Processed in the framer.

Connections

Limited to 256 simple connections on the H.110 bus.

Can simultaneously connect (simplex) to all 4096 timeslots on the H.110 bus.

CT bus timeslot connections

A connection to or from a CT bus timeslot will fail if the timeslot is already connected in the other direction.

If a connection is made to or from a CT bus timeslot, any existing connection in the other direction on that timeslot is disconnected.

DSP connections

Each DSP core has its own 64-slot TSI stream.

Four DSP cores per TSI stream. Each local TSI stream has 128 timeslots.

DSPs

  • 16 or 32 TMS320C549 DSPs.

  • 100 MIPS per DSP core.

  • Up to 3200 MIPS available for voice processing.

  • C5441 DSP. Each chip has four cores.

  • 133 MIPS per DSP core.

  • Maximum 32 cores, 4256 MIPS.

E1 impedance

Default is 120 ohms but switch selectable to 75 ohm.

Software configurable to 75 ohm, 100 ohm, 120 ohm, or high impedance.

Echo cancellation

Software echo cancellation.

Proprietary echo cancellation chip. Software echo cancellation is also available.

Ethernet

No Ethernet connectivity.

Dual 10/100Base-T Ethernet with LED speed and activity indicators on the front panel.

Hot swap

Hot swap monitor (hsmon) displays messages based on whether the board handles are flipped or if the board is physically extracted.

Hot swap monitor (hsmon) does not differentiate between physical extraction of the board and the board handles being flipped when it displays messages. For more information, refer to the Dialogic® NaturalAccess™ OAM System Developer’s Manual.

Signaling

Signaling is switchable from trunk-to-trunk and between trunks and the CT bus.

Does not support switching signaling from trunk-to-trunk or between trunks and the bus, only between trunks and DSPs.

Timeslot Interchangers (TSI)

Dual Agere T8100A.

Proprietary TSI.

Trunk interface jacks

Up to 4 RJ-48C trunk interface jacks.

Varies based on the board variant. Up to 8 RJ-48C interfaces or up to 2 Dialogic® MD1 RJ-21 interfaces.

Trunk LEDs

Red, yellow, and green LED per trunk.

Green status LED per trunk.