The following table summarizes the procedure for installing the hardware and software components:
|
Step |
Description |
|---|---|
|
1 |
Ensure that your PC system meets the system requirements. |
|
2 |
Configure the AG 2000-BRI board. |
|
3 |
Install the AG 2000-BRI board into one of the computer's PCI bus slots. |
|
4 |
If there are multiple H.100 boards, connect the H.100 bus to your H.100 boards. |
|
5 |
Install Natural Access, which also installs the AG 2000-BRI board driver and runtime software. |
|
6 |
Add configuration information for each board to the NMS OAM database. For more information, refer to the NMS OAM System User's Manual. |
|
7 |
Direct the OAM service to start the boards. For more information, refer to Configuring and starting the system with oamsys and to the NMS OAM System User's Manual. |
|
8 |
Verify that the installation is operational. |
Note: If your system is powered down, you can install the board before you install the software. It does not matter if you install the board or the software first.
The following drivers for operating AG boards are installed with Natural Access software:
|
Operating system |
Driver names |
|---|---|
|
Windows |
aghw ag agsw ag95sw |
|
UNIX |
aghw agsw ag95sw agmx |