The following table summarizes the procedure for installing the hardware and software components:
|
Step |
Action |
|---|---|
|
1 |
Ensure that your PC system meets the system requirements. |
|
2 |
Power down the system if it is running. |
|
3 |
If necessary, configure the CG 6565E board for H.100 bus termination. |
|
4 |
Install the CG 6565E board in a PCIe slot. |
|
5 |
Power up the system. |
|
6 |
Install Natural Access, which also installs the CG board driver and runtime software. The hardware interface drivers are installed with NaturalAccess software. |
|
7 |
Create or edit an OAM system configuration file and board keyword file describing your setup. For more information, refer to Configuring and starting the system with oamsys and the Dialogic® NaturalAccess™ OAM System Developer’s Manual. |
|
8 |
Configure the CG 6565E board either without trunk interfaces or with T1 or E1 interfaces as described in Configuring the hardware. |
|
9 |
Configure an Ethernet connection. For more information, refer to the Configuring Ethernet interfaces section. |
|
10 |
Run oamsys to configure the boards as specified in the configuration files. |
|
11 |
Connect the board interfaces to T1 or E1 trunks (if enabled) and Ethernet connections. |
|
12 |
Verify that your installation is operational. |